Debug is a command that you will find in DOS, MS-DOS and Windows. It is known to run on the application “Debug.exe”. This command can help the user by acting as a dissembler as well as an assembler. Simply put, this only means that with the help of this command, the user can actually check the memory of the computer, edit and make changes if necessary, which can further make it easy for the user to run file types like com, exe, etc. In addition, to facilitate easy access to particular disk sectors, memory sectors, specific ports, the debug command is made up of several sub commands.

Originally, the debug command was written by Tim Paterson because it was needless to say that all computer systems needed a maintenance tool and the debug command provided just that. So one thing that you should know is that you should always use the debug command carefully. Because any mistake on your part can result in the loss of sensitive data. Therefore, it is important that you deal with the debug command only if you are well versed with programs or under the guidance of a tech support. You have to know that when you are about to use the debug command, the effect that it is likely to cause may slow down your systems. The computer may slow down if you are debugging on a AS5800 or it may even hang in some cases.

In order to make the debug process easy, it is advised that you check if the CPU load is enough for you to perform the operation. This is the syntax that you use for the debug command: debug [[Drive:][Path] FileName [parameters]]. If you continue to debug repeatedly, you will surely find that your PC will hang. Also, always remember that if you find that the debug output is too large, you can simply use the vty ports. So simply put, debug command is nothing but a tool that that informs the user about the events and protocols of inter-networking activities during a particular timeframe.